A closed-chamber CO2-flux method for estimating intertidal primary production and respiration under emersed conditions

This paper describes a closed-chamber method for measuring CO₂ fluxes in intertidal soft sediments during periods of emersion. The method relies on closed-circuit incubations of undisturbed sediment and measurement of CO₂ exchanges using an infrared gas analyser. The method was assessed during field experiments, both in light and dark conditions, on an exposed sandy beach and in an estuary. The rates of gross community production measured under moderate irradiance (4.2 mg C m^-2 h^-1 on the exposed sandy beach and 35 mg C m^-2 h^-1 in the estuary) are in good agreement with rates reported in the literature. In conjunction with appropriate sampling strategies, this method can be useful for estimating and comparing production of intertidal areas or for assessing factors that influence production.     

Using Lichen Chemistry to Assess Airborne Tungsten and Cobalt in Fallon, Nevada

This paper describes the use of lichen chemistry to assess airborne tungsten and cobalt in Fallon, Nevada, where a cluster of childhood leukemia has been on going since 1997. Lichens and their rock substrates were collected from Rattlesnake Hill within Fallon as well as from four different rock outcrops located north, east, south, and west of Fallon and at least 20 km away from the town center. In the lichens themselves, W and Co are significantly higher within Fallon than in the combined control site outside of Fallon. In the rock substrates of the lichens, no differences exist in W and Co. The W and Co differences in lichens cannot be attributed to substrate geochemistry. Fallon is distinctive in west central Nevada for high airborne W and Co, and given its cluster of childhood leukemia, it stands to reason that additional biomedical research is in order to test directly the leukogenicity of combined airborne W and Co.     

Phosphorus supply influences heathland responses to atmospheric nitrogen deposition

On an upland moor dominated by pioneer Calluna vulgaris and with an understorey of mosses and lichens, experimental plots were treated with factorial combinations of nitrogen (N) at +0 and +20kg Nha(-1)yr(-1), and phosphorus (P) at +0 and +5kg Pha(-1)yr(-1). Over the 4-year duration of the experiment, the cover of the Calluna canopy increased in density over time as part of normal phenological development. Moss cover increased initially in response to N addition but then remained static; increases in cover in response to P addition became stronger over time, eventually causing reductions in the cover of the dominant Calluna canopy. Lichen cover virtually disappeared within 4 years in plots receiving +20kg Nha(-1)yr(-1) and also in separate plots receiving +10kg Nha(-1)yr(-1), but this effect was reversed by the addition of P.     

Characterization of PM2.5 aerosols dominated by local pollution and Asian dust observed at an urban site in Korea during aerosol characterization experiments (ACE)--Asia Project

Daily fine particulate matter (PM2.5) samples were collected at Gwangju, Korea, during the Aerosol Characterization Experiments (ACE)-Asia Project to determine the chemical properties of PM2.5 originating from local pollution and Asian dust (AD) storms. During the study period, two significant events occurred on April 10-13 and 24-25, 2001, and a minor event occurred on April 19, 2001. Based on air mass transport pathways identified by back-trajectory calculation, the PM2.5 dataset was classified into three types of aerosol populations: local pollution and two AD aerosol types. The two AD types were transported along different pathways. One originated from Gobi desert area in Mongolia, passing through Hunshandake desert in Northern Inner Mongolia, urban and polluted regions of China (AD1), and the other originated in sandy deserts located in the Northeast Inner Mongolia Plateau and then flowed southward through the Korean peninsula (AD2). During the AD2 event, a smoke plume that originated in North Korea was transported to our study site. Mass balance closures show that crustal materials were the most significant species during both AD events, contributing -48% to the PM2.5 mass; sulfate aerosols (19.1%) and organic matter (OM; 24.6%) were the second greatest contributors during the AD1 and AD2 periods, respectively, indicating that aerosol properties were dependent on the transport pathway. The sulfate concentration constituted only 6.4% (4.5 microg/m3) of the AD2 PM2.5 mass. OM was the major chemical species in the local pollution-dominated PM2.5 aerosols, accounting for 28.7% of the measured PM2.5 mass, followed by sulfate (21.4%), nitrate (15%), ammonium (12.8%), elemental carbon (8.9%), and crustal material (6.5%). Together with substantial enhancement of the crustal elements (Mg, Al, K, Ca, Sc, Ti, Mn, Fe, Sr, Zr, Ba, and Ce), higher concentrations of pollution elements (S, V, Ni, Zn, As, Cd, and Pb) were observed during AD1 and AD2 than during the local pollution period, indicating that, in addition to crustal material, the AD dust storms also had a significant influence on anthropogenic elements.     

Vanadium recovery from oil fly ash by leaching, precipitation and solvent extraction processes

In order to reduce the environmental impact due to land disposal of oil fly ash from power plants and to valorize this waste material, the removal of vanadium was investigated using leaching processes (acidic and alkaline treatments), followed by a second step of metal recovery from leachates involving either solvent extraction or selective precipitation. Despite a lower leaching efficiency (compared to sulfuric acid), sodium hydroxide was selected for vanadium leaching since it is more selective for vanadium (versus other transition metals). Precipitation was preferred to solvent extraction for the second step in the treatment since: (a) it is more selective; enabling complete recovery of vanadate from the leachate in the form of pure ammonium vanadate; and (b) stripping of the loaded organic phase (in the solvent extraction process) was not efficient. Precipitation was performed in a two-step procedure: (a) aluminum was first precipitated at pH 8; (b) then ammonium chloride was added at pH 5 to bring about vanadium precipitation.     

蚯蚓生态滤池处理农村生活污水现场试验研究

对蚯蚓生态滤池处理太湖流域农村生活污水进行现场试验研究.通过对蚯蚓同化容量与污染负荷进行单因素分析,得出蚯蚓生态滤池处理农村生活污水的运行参数与运行方式,并据此进行连续运行试验.结果表明,在表面水力负荷1 m3/(m2*d)、湿干比(布水时间和落干时间之比)1∶3、蚯蚓负荷(以单位体积填料中蚯蚓的质量计)12.5 g/L的条件下,蚯蚓生态滤池处理农村生活污水具有可行性与高效性,单级系统的COD、总氮、氨氮和总磷的去除率分别在81%、66%、82%和89%左右.改进蚯蚓床填料、设计通风结构和采取适宜运行方式,是蚯蚓生态滤池成功应用于农村生活污水处理的三大重要因素.     

Modeling Parent and Metabolite Fate and Transport in Subsurface Drained Fields With Directly Connected Macropores1

Abstract: Few studies exist that evaluate or apply pesticide transport models based on measured parent and metabolite concentrations in fields with subsurface drainage. Furthermore, recent research suggests pesticide transport through exceedingly efficient direct connections, which occur when macropores are hydrologically connected to subsurface drains, but this connectivity has been simulated at only one field site in Allen County, Indiana. This research evaluates the Root Zone Water Quality Model (RZWQM) in simulating the transport of a parent compound and its metabolite at two subsurface drained field sites. Previous research used one of the field sites to test the original modification of the RZWQM to simulate directly connected macropores for bromide and the parent compound, but not for the metabolite. This research will evaluate RZWQM for parent/metabolite transformation and transport at this first field site, along with evaluating the model at an additional field site to evaluate whether the parameters for direct connectivity are transferable and whether model performance is consistent for the two field sites with unique soil, hydrologic, and environmental conditions. Isoxaflutole, the active ingredient in BALANCE^® herbicide, was applied to both fields. Isoxaflutole rapidly degrades into a metabolite (RPA 202248). This research used calibrated RZWQM models for each field based on observed subsurface drain flow and/or edge of field conservative tracer concentrations in subsurface flow. The calibrated models for both field sites required a portion (approximately 2% but this fraction may require calibration) of the available water and chemical in macropore flow to be routed directly into the subsurface drains to simulate peak concentrations in edge of field subsurface drain flow shortly after chemical applications. Confirming the results from the first field site, the existing modification for directly connected macropores continually failed to predict pesticide concentrations on the recession limbs of drainage hydrographs, suggesting that the current strategy only partially accounts for direct connectivity. Thirty‐year distributions of annual mass (drainage) loss of parent and metabolite in terms of percent of isoxaflutole applied suggested annual simulated percent losses of parent and metabolite (3.04 and 1.31%) no greater in drainage than losses in runoff on nondrained fields as reported in the literature.     

A new method to quantify the impact of soil carbon management on biophysical soil properties: the example of two apple orchard systems in New Zealand

A new method to diagnose the environmental sustainability of specific orchard management practices was derived and tested. As a significant factor for soil quality, the soil carbon (C) management in the topsoil of the tree-row of an integrated and organic apple orchard was selected and compared. Soil C management was defined as land management practices that maintain or increase soil C. We analyzed the impact of the soil C management on biological (microbial biomass C, basal respiration, dehydrogenase activity, respiratory quotient) and physical (aggregate stability, amount of plant-available water, conductive mean pore diameter near water saturation) soil properties. Soil in the alley acted as a reference for the managed soil in the tree row. The total and hot-water-extractable C amounts served as a combined proxy for the soil C management. The soil C management accounted for 0 to 81% of the degradation or enhancement of biophysical soil properties in the integrated and organic system. In the integrated system, soil C management led to a loss of C in the top 0.3 m of the tree row within 12 yr, causing a decrease in microbial activities. In the tree row of the organic orchard, C loss occurred in the top 0.1 m, and the decrease in microbial activities was small or not significant. Regarding physical soil properties, the C loss in the integrated system led to a decrease of the aggregate stability, whereas it increased in the organic system. Generally, the impact of soil C management was better correlated with soil microbial than with the physical properties. With respect to environmental soil functions that are sensitive to the decrease in microbial activity or aggregate stability, soil C management was sustainable in the organic system but not in the integrated system.     

A directional passive air sampler for monitoring polycyclic aromatic hydrocarbons (PAHs) in air mass

A passive air sampler was developed for collecting polycyclic aromatic hydrocarbons (PAHs) in air mass from various directions. The airflow velocity within the sampler was assessed for its responses to ambient wind speed and direction. The sampler was examined for trapped particles, evaluated quantitatively for influence of airflow velocity and temperature on PAH uptake, examined for PAH uptake kinetics, calibrated against active sampling, and finally tested in the field. The airflow volume passing the sampler was linearly proportional to ambient wind speed and sensitive to wind direction. The uptake rate for an individual PAH was a function of airflow velocity, temperature and the octanol-air partitioning coefficient of the PAH. For all PAHs with more than two rings, the passive sampler operated in a linear uptake phase for three weeks. Different PAH concentrations were obtained in air masses from different directions in the field test.     

Temporal and spatial distributions of sediment total organic carbon in an estuary river

Understanding temporal and spatial distributions of naturally occurring total organic carbon (TOC) in sediments is critical because TOC is an important feature of surface water quality. This study investigated temporal and spatial distributions of sediment TOC and its relationships to sediment contaminants in the Cedar and Ortega Rivers, Florida, USA, using three-dimensional kriging analysis and field measurement. Analysis of field data showed that large temporal changes in sediment TOC concentrations occurred in the rivers, which reflected changes in the characteristics and magnitude of inputs into the rivers during approximately the last 100 yr. The average concentration of TOC in sediments from the Cedar and Ortega Rivers was 12.7% with a maximum of 22.6% and a minimum of 2.3%. In general, more TOC accumulated at the upper 1.0 m of the sediment in the southern part of the Ortega River although the TOC sedimentation varied with locations and depths. In contrast, high concentrations of sediment contaminants, that is, total polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs), were found in sediments from the Cedar River. There was no correlation between TOC and PAHs or PCBs in these river sediments. This finding is in contradiction to some other studies which reported that the sorption of hydrocarbons is highly related to the organic matter content of sediments. This discrepancy occurred because of the differences in TOC and hydrocarbon source input locations. It was found that more TOC loaded into the southern part of the Ortega River, while almost all of the hydrocarbons entered into the Cedar River. This study suggested that the locations of their input sources as well as the land use patterns should also be considered when relating hydrocarbons to sediment TOC.